Kaynak: www.cisco.com


Performing a Factory Reset

When you perform a factory reset of the Cisco Unified IP Phone, the following information is erased or reset to its default value:

• User configuration settings—Reset to default values

• Network configuration settings—Reset to default values

• Call histories—Erased

• Locale information—Reset to default values

• Phone application—Erased (phone recovers by using the image in the inactive partition of flash to boot up).


Before you perform a factory reset, ensure that the following conditions are met:

• The phone must be on a DHCP-enabled network.

• A valid TFTP server must be set in DHCP option 150 or option 66 on the DHCP server.


To perform a factory reset of a phone, perform the following steps:


Step 1 Unplug the power cable from the phone and then plug it back in.

The phone begins its power-up cycle.

Step 2 While the phone is powering up, and before the Speaker button flashes on and off,

press and hold #.

Continue to hold # until each line button flashes on and off in sequence in amber.

Step 3 Release # and press 123456789*0#.

You can press a key twice in a row, but if you press the keys out of sequence, the factory reset will not take place.

After you press these keys, the line buttons on the phone flash red, and the phone goes through the factory reset process.

Do not power down the phone until it completes the factory reset process, and the main screen appears.